Difference between revisions of "Xen Project Maintenance Releases"
|Line 76:||Line 76:|
Revision as of 09:40, 28 November 2012
Stable Maintenance Branches
Each new Xen release X.Y.0 starts a new stable maintenance branch.
Each such branch is in its own mercurial repository xen-X.Y-testing.hg. See Xen Repositories for more information about the current branches.
Releases are intended to happen roughly every 3 months. The first release on a stable branch is often sooner and as the branch reaches the end of its life the interval may be longer.
In general Xen.org supports the two most recent stable branches at any given time. When a new X.Y.0 release is made there is usually one more release on the to-be-retired stable branch to mop up any loose patches sitting in the repository at which point the branch is retired.
For example at the time of writing we are in the 4.3 development cycle and are supporting two stable branches: 4.1-testing and 4.2-testing. After 4.2.0 was released there was one more release in the 4.0-testing stream (4.0.4) and then the 4.0 branch was retired.
Stable Branch Maintainer
Each stable branch has a maintainer who is nominated/volunteers according to the Maintainer Election process described in the project governance document. This will resulting in the MAINTAINERS file in the relevant branch being patched to include the maintainer.
For the branches maintained by Xen.org one of the regular xen-unstable committers or maintainers would usually step up as maintainer. However other community members can also step up to maintain a stable release, typically once Xen.org no longer does so.
The stable branch maintainer is responsible for identifying suitable candidates for inclusion in the stable branch both according to their own judgment and by evaluating requests from the community (see below).
Stable Branch Patch Inclusion Policy
No new development happens in the X.Y-testing branches, instead changesets are backported from xen-unstable. Where this is not possible (perhaps unstable has moved on such that the patch cannot be applied or the approach used in unstable is otherwise not valid for the stable branch) then a specific fix can be created for the stable branch. However it is a requirement that the issue will always be fixed in unstable first (this is to avoid regressions on the next major release).
In general only bug fixes are accepted into stable branches and new features are not normally accepted. (There can be exceptions, e.g. it was agreed that 4.2.1 would take a more relaxed approach to features which improved xl compatibility with xm). As time passes each stable branch becomes more conservative and the barrier to accepting a patch for backport becomes higher.
Changesets are included in the stable branch at the discretion of the branch maintainer.
Requesting A Backport
As well as changesets identified by the branch maintainer as being suitable for backport changes can also be nominated for inclusion in the stable branch by making a request to the stable maintainer on xen-devel either by noting it as such in the submission of the original patch to xen-unstable or by a subsequent explicit email to xen-devel.
Backport requests should always be copied to the relevant stable maintainer. In addition as part of the the stable release process the stable maintainer will send one or more requests to xen-devel soliciting suggestions for patches which should be included.